ContributionsFollow the blue link(s) below for abstracts and full text pdfs .
Author index ►Christian Clasen, H. Pirouz Kavehpour, Gareth H. McKinley
Most cited recent articles ►
Articles for free download ►
Search conferences ►
Bridging Tribology and Microrheology of Thin Films
Appl. Rheol. 20:4 (2010) 45049 (13 pages) ►
An enhanced version of the flexure-based microgap rheometer (FMR) is described which enables rheological measurements in steady state shearing flows of bulk fluid samples of PDMS with an absolute gap separation between the shearing surfaces of 100 nm - 100 μmm. Alignment of the shearing surfaces to a parallelism better then 10-7 rad allows us to reliably measure shear stresses at shear rates up to 104 s-1. At low rates and for shearing gaps < 5 mm the stress response is dominated by sliding friction between the surfaces that is independent of the viscosity of the fluid and only determined by the residual particulate phase (dust particles) in the fluid.This behaviour is similar to the boundary lubrication regime in tribology.The absolute gap control of the FMR allows us to systematically investigate the flow behaviour at low degrees of confinement (gap separations 100 nm - 2 μm) that cannot be accessed with conventional (controlled normal load) tribological test protocols.► Cite this publication as follows:
Clasen C, Kavehpour HP, McKinley GH: Bridging Tribology and Microrheology of Thin Films, Appl. Rheol. 20 (2010) 45049.
© Applied Rheology 2023