Applied Rheology: Publications
You have network access to this resource: olauk528 [1638]
Christian Clasen, H. Pirouz Kavehpour, Gareth H. McKinley
Bridging Tribology and Microrheology of Thin Films

Appl. Rheol. 20:4 (2010) 45049 (13 pages)

Abstract: An enhanced version of the flexure-based microgap rheometer (FMR) is described which enables rheological measurements in steady state shearing flows of bulk fluid samples of PDMS with an absolute gap separation between the shearing surfaces of 100 nm - 100 μmm. Alignment of the shearing surfaces to a parallelism better then 10-7 rad allows us to reliably measure shear stresses at shear rates up to 104 s-1. At low rates and for shearing gaps < 5 mm the stress response is dominated by sliding friction between the surfaces that is independent of the viscosity of the fluid and only determined by the residual particulate phase (dust particles) in the fluid.This behaviour is similar to the boundary lubrication regime in tribology.The absolute gap control of the FMR allows us to systematically investigate the flow behaviour at low degrees of confinement (gap separations 100 nm - 2 μm) that cannot be accessed with conventional (controlled normal load) tribological test protocols. © 2010 Applied Rheology.

DOI 10.3933/ApplRheol-20-45049

-- full text PDF available for subscribers --

-- open access PDF extract available for non-subscribers --


You have no password-free access to Applied Rheology Online. If you are a subscriber, enter login details below. For password-free access, we need your IP address. Sample manuscripts for free download can be found here

download to disk (some browsers prefer this option)
login name
password

Purchase this article for 20 € ?

Forgotten your login details? Send an email with subject "AR login" to login@appliedrheology.org


Appl Rheol 20 (2010) issues:

           


© Applied Rheology 2018